Pool installation for Fairview properties
Fairview is good ground for a pool, whether your land is valley bottom or the slope above it. We install all four shell types here: precast, fiberglass, gunite and container. Having the full range available is why a pool is workable on the flat farm land in the valleys and on the steeper property around them.
The community sits at about 2,274 feet in southeastern Buncombe County, eleven miles down US 74A from downtown Asheville and about sixteen miles from Lake Lure. The area has been described as rich farm valleys inside protective mountain walls, and that is still an accurate description of it.
The valleys themselves are farmland. The bottom ground is gentle, the soil is deep, and it has been worked for generations. On that ground a pool is a manageable build: the digging is straightforward, a crane can generally get where it needs to be, and the budget goes into the pool rather than into moving the hillside.
The land around those valleys is steep. On a steep lot the only flat area is often the shelf the house already sits on. A pool up there is a bigger build. It takes more site work and it costs more.
Water is the Fairview-specific factor
Parts of these valleys were marsh that had to be drained before the land could be farmed. Farm drainage from that era is still in the ground. Low-lying parcels around Gash’s Creek, recorded historically as Cripple Creek, and the other valley bottoms can hold water, sit on a high water table, or drain slowly.
If your low spots stay wet after rain, that is not a defect in your property but a normal condition for this valley. Wet ground does decide things, though: where the pool goes, whether it sits raised instead of sunk, and how much drainage gets built in from the start.
On sloping ground the problem is the opposite, because water is not sitting but running downhill toward wherever the pool is going. Either way, drainage gets designed and built at the same time as the pool instead of being added later.

